Door configs

Settings

To create a new door in Telcred Access Manager, it is first necessary to create a door config. The door config contains the door's name and some technical parameters, which are typically set by the installer/integrator:

• Name. Should be something meaningful to both the administrator and the end users.
• Directional. Directional doors are explained here. The default is no.
• Access time. This is the time the lock stays unlocked after a credential has been accepted by the reader.
• Open too long alarm. After this time the alert Door left open will be generated and the reader will indicate an alarm.
• Pre-alarm. The number of seconds before Open too long time that the reader will warn the user to close the door.
• Suppress forced open. With this setting, no Door forced open alerts will be generated. This can be relevant where the door is equipped and configured with a door monitor but opened manually from the inside (as opposed to with a REX device). Note: If the door has a reader, the reader will still indicate Door forced open even though it is ignored in Telcred Access Manager.

After having created a door config, it can be linked to the right controller on the controller page.