Doors

Settings

On the door detail page, the administrator can see and change settings relevant to the individual door. The settings are:

• Name. Should be something meaningful to the administrator (and the end users if they use mobile access through either Telcred Entry or Visits).
• Description. Optional
• Door groups. Optional. For more information on door groups, see this page.
• Access time. This is the time the lock stays unlocked after a credential has been accepted by the reader.
• Open too long alarm. After this time the alert Door left open will be generated and the reader will indicate an alarm.
• Pre-alarm. The number of seconds before Open too long time that the reader will warn the user to close the door.
• Unlock. The door will be unlocked according to a schedule (e.g. weekdays between 09.00 and 17.00). If the door has two locks, both will be unlocked.
• Unlock lock 2 only. Allows to unlock only the second lock according to a schedule (typically a night lock / motor lock).

Status

Three statuses are displayed in the right-hand column for a door:

• Controller status
• Lock state
• Door state

Possible values for Controller status are:

• Online
• Offline
• Incomplete configuration. This means that the controller is not fully configured yet and has never been online.
• Ready to connect. This means that the controller is fully configured and ready to be connected to the Telcred service.

Possible values for Lock state are:

• Unlocked
• Locked. The door is locked with one lock. If the door has two locks, lock 2 is unlocked.
• Double locked. The door has two locks and both are locked.
• Unknown. It is not possible to determine the lock state, e.g. because the controller has not been configured yet.

Possible values for Door state are:

• Open
• Closed
• Unknown

If the door has no door monitor, the door state will always be unknown. It could also be unknown due to the fact that the controller is currently offline.

Actions

It is possible for an administrator, or officer, to Grant access on a door. This is equivalent to presenting a valid credential to the reader (or using one of the mobile access methods). The door will unlock for the time determined by the Access time setting, an alert will be triggered if the door is open longer than the time defined by the Open too long alarm setting, etc. In the Events log, the Method will be recorded as Officer and no user will be displayed.

A second group of actions have to do with overriding the schedule(s) that determine when the door's lock(s) should unlock. It is possible to override whatever lock state the door is in to one of:

• Unlocked
• Locked
• Double locked

A door where Override schedule has been set will stay in this state until the administrator presses Return to schedule. When this happens the door will switch back to whatever lock state it should have been in at that time according to the schedule(s) defined for Unlock and Unlock lock 2 only.